Learning Center
HVAC glossary
The words you'll hear from a technician, explained in plain English.
HVAC terms, A to Z
- Air handler
- The indoor unit that moves air through your ductwork. It holds the blower and usually the evaporator coil.
- BTU
- British Thermal Unit, a measure of heat. Air conditioner capacity is measured in BTUs per hour; 12,000 BTU per hour equals one ton.
- Capacitor
- An electrical part that gives the compressor and fan motors the boost they need to start and run. A weak capacitor can keep a compressor or fan from starting. Read: Locked compressor? What a start-assist kit can (and can't) fix →
- Change-out
- Replacing the whole AC and heating system rather than a single part. With Scott Niehaus AC it includes permits, a 1-year parts and labor warranty, and a 10-year manufacturer parts warranty on registration. Read: What a full HVAC change-out includes →
- Compressor
- The pump in the outdoor unit that moves refrigerant through the system. It is the heart of an air conditioner and the most expensive part to replace. Read: Locked compressor? What a start-assist kit can (and can't) fix →
- Condensate drain
- The line that carries water the AC removes from the air out of the house. If it clogs, a float switch may shut the system off to prevent water damage. Read: AC not cooling? Safe checks before you call →
- Contactor
- The electrical switch in the outdoor unit that turns the compressor and fan on and off when the thermostat calls for cooling.
- EPA Section 608 certification
- The federal certification required of technicians who maintain, service, repair or dispose of equipment that could release ozone-depleting refrigerants. Scott Niehaus AC's field technicians hold it. Read: What happens during an HVAC diagnostic visit →
- Evaporator coil
- The cold indoor coil that absorbs heat from your home's air and pulls moisture out of it. Read: Humidity, short cycling and your AC in North Central Florida →
- Heat pump
- A system that cools like an air conditioner in summer and runs in reverse to heat the house in winter.
- Mechanical permit
- The permit issued by your local building department for HVAC system installations. Scott Niehaus AC pulls it for every installation. Read: HVAC permits in Alachua and Gilchrist counties →
- R-22
- An older refrigerant whose production and import ended in 2020. Leaking R-22 systems are expensive to recharge and often point to a change-out. Read: Should you repair or replace your AC? →
- SEER / SEER2
- Seasonal Energy Efficiency Ratio, a measure of cooling efficiency. A higher number means less electricity for the same cooling. SEER2 is the newer test standard.
- Short cycling
- When a system turns on and off every few minutes. It hurts dehumidification and wears out equipment. Read: Humidity, short cycling and your AC in North Central Florida →
- Start-assist (hard start) kit
- An add-on that gives a struggling compressor extra starting torque. It can bring a stuck compressor back; it can't fix failed windings. Read: Locked compressor? What a start-assist kit can (and can't) fix →
- Thermal overload
- A built-in safety that shuts a motor or compressor off when it overheats, such as when a locked compressor draws too much current. Read: Locked compressor? What a start-assist kit can (and can't) fix →
